EverFocus ED300 Series Manual do Utilizador descarregar pdf (Página 11)

1. Remove the plastic dome cover.

2. Lossen the two screws of the supporting bracket to remove the

camera body.

3. Using four screws to fix the camera base on the ceiling.

4. Put the camera body back to the supporting bracket, then tighten the

two screws to fix the camera.

5. Connect the BNC connector of the camera to a color monitor, or

other video device through a 75 ohm type coaxial cable with BNC

female connector at cable extension.

6. Connect the DC+12V regulated power source of the camera (DC

Jack) to the DC12V Power-in jack with 2mm, center+, outer- plug.

7. Connect the audio output connector of the camera(model ED300A)

to the audio in connector of the monitor.

NOTE:

Be very careful not to scratch or damage the lens while making any kind of

setting.

Installation Instructions

1 2 ... 6 7 8 9 10 11 12 13 14 15

Sem comentários

EverFocus ED300 Series Manual do Utilizador Página 11