EVERFOCUS 1/3” Wide-Dynamic True D/N Rugged Dome Color Camera Operation Instructions Model No. EHD650 Please read this manual first for correct ins
- 10 - d. Tighten fixing screws and finished 2.2 Mounting Cameras on the Ceiling/Wall a. Mount the base to the wall or ceiling, fix the base by th
- 11 - b. Take off cable conduit if you need to wire cable through side conduit hole. The camera comes with a conduit plug pre-installed in the PF 1/2
- 12 - b. Connect cable conduit to the conduit hole and make it tight. c. Connect the power supply cable (24VAC), video output to the prope
- 13 - e. Optional connect to Alarm(Please see figure 8 for terminal functions) f. V. Phase adjustment screw is located on the termin
- 14 - 2.4 Adjust Lens zoom and focus and View a. Adjust Lens zoom and focus(for vari-focal lens models) b.
- 15 - 3. HOW TO CONTROL OSD MENU 3.1 Where is OSD Controller Detach the mini-joystick on the side of camera housing. See the following picture.
- 16 - I. Press the SET button for 3 seconds The menu screen will appear on the monitor as the block shown above. II. Using the cursor button Use
- 17 - 4. MAIN MENU 4.1 Setup ID Camera Menu: Display ID/Camera ID/ID position DISPLAY ID: ON/OFF. The camera ID can be displayed on
- 18 - ID POSITION: UP-LEFT / UP-CENTER / UP-RIGHT / DWN-LEFT / DWN-CENTER / DWN-RIGHT There are four positions can be chosen to show the CAMERA I
- 19 - 4.3 WDR (Wide Dynamic Range) EXPO BIAS: MIN -18 ~ 18 MAX Select exposure bias from min. -18 to max. 18. WDR BIAS: MIN –20 ~ 20 MAX The
- 2 - TABLE OF CONTENTS 1. PRODUCT OVERVIEW ...
- 20 - WB CONTROL: ATW ATW (Auto Tracking White Balance): This mode can be used within the color temperature range from 2,500°K to 9,500°K (eg, fluo
- 21 - AGC MENU: SET LEVEL from MIN –34 to MAX 43. The more the level of gain increases, the brighter the screen and the level of noise i
- 22 - 4.7 SYNC SYNC: INTERNAL/LINELOCK SYNC-INTERNAL Internal synchronization. SYNC – LINELOCK Phase adjustment may be neces
- 23 - 4.8 Day/Night Auto/COLOR/B/W DAY/NIGHT: Auto. For automatic switch between day and night mode. C->B 20~35 B->C 0~10
- 24 - SAVE RESTORE EXIT: RESTORE FACTORY SETTING RESTORE FACTORY SETTING: you will be asked “Are you sure?” before you restore all set
- 25 - EverFocus Electronics Corp. Head Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886-2-26982334 FAX: +886-2-2698
- 3 - 1. PRODUCT OVERVIEW The most technically advanced EHD650 is the newest vandal-resistant Color Rugged Dome Camera from EverFocus Electronics. Th
- 4 - 1.2 Package Contents z Camera Unit x 1 z Mounting Accessory includes: - Screws x 4 - Expanding Screws x 4 - Wrench x 1 z Weather-proo
- 5 - 1.3 Specifications Pickup Device 1/3'' DPS Wide Dynamic range sensor Video Format NTSC or PAL Scanning System NTSC: 525 TV lines, 60 f
- 6 - 1.4 Dimensions a. b.
- 7 - 1.5 Hardware Overview Conduit plug setscrew Side conduit hole Back conduit hole Mounting Setscrew Mounting Setscre
- 8 - 2. INSTALLATION This section covers simple steps and detail installation. Please follow instruction for preventing any unnecessary damage. Simp
- 9 - To remove the camera, first unplug the wire connection on the back of the camera. Then loosen the 2 locking screws on the camera base, push the
Comentários a estes Manuais