EverFocus EBC890 Manual do Utilizador descarregar pdf (Página 29)

2121

Connecting Power

Connecting the Power Supply

Connect the positive end to the terminal 47 and the GND to terminal 48 as shown in

Fig. 24.

Fig. 24. Connecting the Power Supply

The power supply for fingerprint controller should range in DC 12V±15%. The minimum

output of power supply should be no less than 1.5A.

Important Tips: The voltage supply should be located no more than 2 meters/7 feet from the

controller. Also, electric locks and alarm devices MUST be powered separately.

Reset Controller

Before turning the power on, please double check to ensure that all the wiring and connections

are correct. In order to restore factory default settings, switch the power on while holding

down the RESET switch. The RESET switch is shown in

Fig. 25.

Fig. 25. Reset Controller

Important Note: Doing reset will erase all data, settings.

Chapter

Reset

V+ V

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Sem comentários

EverFocus EBC890 Manual do Utilizador Página 29