EverFocus PowerVideo Plus Manual do Utilizador descarregar pdf (Página 46)

PowerVideo Plus

10.1 Activating the Alarm Function

You have to configure the settings on the Web interfaces of the DVR / Mobile DVR / NVR or

IP cameras, and then configure the protocol and port settings of the Alarm Server to activate

the alarm function.

• On the Web interface of the DVR:

a. Check the Enable box and enable the Network Alarm function on the Motion, Video

Loss or Alarm / Event settings page.

Figure 10-2

b. On the Network settings page, click Alarm Server, type the IP address of the local

computer, select a Protocol and enter 1600 in the Port field. Type a 10-digit network

ID for network identification.

Figure 10-3

Note: All devices connected to the PowerVideo Plus have to be set up with a 10-digit

network ID for the Alarm Server to work.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 79 80

Sem comentários

EverFocus PowerVideo Plus Manual do Utilizador Página 46