EverFocus EMV200 DVR Manual do Utilizador descarregar pdf (Página 44)

4.4.5 Alarm-GPS Event Action

Press to enter GPS Event Action Menu.

Figure 4-22 Alarm – GPS Event Action

Alarm Output: This will transmit a signal through the alarm output relay. It can be set to either “NONE” (not

active), “1” (active) or “2” (active).

Output Type: Output action when alarm is triggered.

Timeout: Alarm output lasts for the set time duration.

Permanent: Alarm will be continuously active until user presses “Enter” key.

Transparent: Alarm output remains active until event ends.

Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.

Timeout Duration: The amount of time the buzzer sounds when GPS event occurs. Duration selectable from 1 to

150 seconds.

Pre-alarm Record: Check box to start copying recorded video to the hard disk from 5 seconds before the video

loss. (Pre-alarm recording rate will follow the “Normal” frame rate setting)

Email Notify: Check box to enable email notification when GPS event occurs. Email operation requires that valid

email settings have been entered in the Network Setting/Email setup screen.

Network Alarm: Check box to send out a network alarm to client PC. (requires PowerCon software and setting up

Alarm Server in Network Setup menu)

Click button to return to the previous level of menu.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 101 102

Sem comentários

EverFocus EMV200 DVR Manual do Utilizador Página 44