EverFocus EHN Series Manual do Utilizador descarregar pdf (Página 12)

EHN Series Mini Rugged IP Dome

3. Attach and then screw the camera to the wall / ceiling using the supplied three Long Screws.

4. Thread the cables.

a. From the side cut of the camera case: remove the plug from the camera case first.

Remove the Plug

b. Through the wall / ceiling: run the cables through the hole on the wall / ceiling.

5. Connect the network, power or audio cables to the camera.

6. Optionally insert a micro SD / SDHC card to the card slot. See No.2 in 2. Physical Description.

7. Access the camera live view. See 5.1 Checking the Dynamic IP Address. Or using the supplied Video

Test-Out cable to connect a monitor to the Video Test-Out connector (see No.4 in 2. Physical

Description) of the camera for adjusting camera angles.

Note: Do Not adjust camera focus yourself as it has already been adjusted (with the dome

cover on) in the factory. It is normal to see the blurry image on the live view when the camera

is connected to a monitor without the dome cover on. The live view image will be focused

once the dome cover has been put back to the camera.

Pan Adjustment: Loosen the screw and pan the camera by ±25°.

±25°

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 68 69

Sem comentários

EverFocus EHN Series Manual do Utilizador Página 12