EverFocus EDSR100H Manual de Instruções descarregar pdf (Página 16)

LAN Connector : The RJ-45 LAN connector.

LAN

ALM-NC : Normal Close Alarm output. In normal condition, this terminal is

shorted to the terminal of ALM-COM. In alarm status, it is open

between ALM-NC and ALM-COM terminals.

ALM-NO : Normal Open Alarm output. In normal condition, this terminal is

open from the terminal of ALM-COM. In alarm status, those two

terminals are shorted.

ALM-COM : Alarm Common Contact.

SW OUT : Step signal to synchronize the machine and multiplexer.

DISKFULL : Disk-Full alarm signal.

Alarm Output

Alarm Output Terminal Block

RS232

RS232 connector : Connect D-Sub 9 pins connector to RS232 ports for remote control

Back Panel Connections

ALM-IN : Normal Open or Normal Close type alarm sensor input.

The Alarm Input can be selected as Normal Open or Normal Close input in the setup

menu. When an alarm occurs, alarm recording will automatically start.

ALM-RST : Normal Open or Normal Close type alarm reset input to reset the alarm.

REC : External Recording request signal. The machine will start recording when a High Level

is applied on this input terminal. If the machine is not in the timer, recording mode,

the machine will stop recording when the REC signal drops from High to Low level.

Alarm Input

Alarm Input Terminal Block

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 56 57

Sem comentários

EverFocus EDSR100H Manual de Instruções Página 16